Wiring the Bass Kill Switch
Parts needed:
-wire
-DPDT switch
-4-pin female connector
notes:
-the wiring used in this tutorial works for the preamp kit, nanofader 1.2, and nanofader 2.flesh
-wire length depends on where the switch is mounted
-wire length does not affect performance
-Switch Side
1. Solder a wire to the switch terminal as shown in pic_1_wire1
2. Solder a second wire to the switch terminal as shown in pic_2_wire2
3. Solder a third wire to the switch terminal as shown in pic_3_wire3
4. Solder a fourth wire to the switch terminal as shown in pic_4_wire4
-Twist Wires
6. Twist the wires as shown in pic_5_twist. This will help organize the wires into pairs.
-Connector Side
7. Solder one pair of wires to the connector as shown in pic_6_pair1
8. Solder the second pair of wires to the connector as shown in pic_7_pair2
-Complete
9. See pic_8_complete for the completed wire assembly
Where does it plug into?
The four pin “bass kill” header on the preamp kit or nanfader boards.
Could you make another pic to show where and how to wire the switch to the preamp ?
I got it !!
Sorry, I just saw this. Sounds like you figured it out…